Tronic TPB 10000 A1 Operation And Safety Notes

GB/IE/NI 16
Checking the battery status
You can check the battery status via the LED indicator
7
of the
power bank
3
at anytime.
Briefly press the ON / OFF button
6
. The LED indicator
7
shows the approximate charge status of the internal
battery capacity level for approx. 30 seconds.
Charging mobile devices with the
power bank
You can charge up to two devices at the same time using the
power bank
3
. If all outputs are used at the same time, the
sum of the output current may not exceed 3 A.
To charge your QuickCharge 3.0 enabled device, connect
the USB Type A plug of USB cable
4
or the original USB
Type A to USB Type C charging cable of the device to
be charged to the USB type A output
2
which supports
QuickCharge 3.0. Then connect the USB Type C plug of the
USB cable
4
to the USB Type C input port of the device to
be charged. The charging process will start automatically.
NOTE: You could also charge your conventional USB
devices from the USB Type A output port
2
of the power bank
using the included USB cable
4
or a USB Type A to micro
USB cable (not included).
To charge your USB Power Delivery (PD) enabled device,
connect the USB Type C plugs of your USB Type C to Type
C cable (not included) to the PD port
1
of the power bank
and the PD port of the device to be charged. The charging
process will start automatically.
In case if the charging process does not begin immediately,
press the ON / OFF button
6
briefly to begin the charging
process. The current battery status of the power bank
3
is

Tronic TPB 10000 A1 Specifications

General

Brand	Tronic
Model	TPB 10000 A1
Category	Accessories
Language	English