Trotec AIRGOCLEAN 11 E - HEPA Filter Replacement Process; Complete Filter Change and Reset

12 EN
air cleaner AirgoClean® 11 E
2. Take the used HEPA carbon filter(17) out of the device.
17
3. Dispose of the used HEPA carbon filter according to the
national regulations.
4. Take the new HEPA carbon filter out of the plastic cover.
5. Insert the new HEPAcarbon filter(17) into the device.
17
6. Reassemble the bottom plate(16) and the device by
turning the bottom plate in the Close direction of the arrow.
Make sure that the two arrows of the marking(18) are
positioned exactly on top of each other.
16
18
Proceed as follows to reset the filter changeLED(6).
ü The device is now in standby mode.
1. Press the fan speed button(9) for more than 2seconds.
2. Press the on/off(11)button to switch the device back on.