Trotec AIRGOCLEAN 200 E - HEPA Filter Replacement Procedure; Resetting Filter Indicators

EN 13
air cleaner AirgoClean® 200 E
2. Remove the prefilter(20) from the device.
20
3. If necessary, clean the prefilter(20) as described in
Cleaning the prefilter.
4. Pull the strips(22) to take the HEPA carbon filter(21) out of
the device.
22
21
5. Dispose of the HEPA carbon filter according to the national
regulations.
6. Take the new HEPA carbon filter out of the plastic cover.
7. Insert the new HEPAcarbon filter into the device. Make
sure that the strips(22) are positioned on the outside.
22
21
8. Reinsert the prefilter(20) into the device.
20
9. Put the air inlet(3) back on the device.
3
10. Press the Air quality button(9) for three seconds to reset
the Prefilter LED(19) or HEPA carbon filter LED(18).