EN 7
infrared heating panel TIH 300 S / TIH 400 S / TIH 500 S / TIH700 S / TIH 900 S / TIH 1100 S
2. Attach the template to the wall using adhesive tape or
similar.
3. Drill the holes into the wall at the positions marked on the
template.
4. Remove the template from the wall.
5. Insert suitable wall plugs into the drill holes.
6. Insert the screws into the wall plugs and fasten the
screws.
ð The screws should protrude approx. 0.5 cm from the
wall plugs.
7. Hang the device in.
Assembling the feet (optional)
The feet can optionally be attached to the device in order to be
able to position the device in the room.
The accessories for the feet are not included in the scope of
delivery.
When positioning the device, observe the minimum distance
from walls or other objects as described in the Technical data
chapter.
For assembling the feet, please proceed as follows:
ü Work together with another person who helps you to lift the
device during assembly of the feet.
1. Hold the feet available.
2. Lift the device with the help of another person.
To Next Page
Loading...
Need help?
General
