8 EN
dehumidifier TTK 99 HEPA
Inserting the air filter and HEPA filter
Note
Remove any packing material from the HEPA filter. To
change the filter, proceed as described in the
Maintenance chapter under Cleaning and replacing the
HEPA filter.
Note
Do not operate the device without an air filter inserted
into the air inlet!
Without the air filter, the inside of the device will be
heavily contaminated. This could reduce the
performance and result in damage to the device.
• Before switching the device on, make sure that the air
filter and HEPA filter are installed.
Inserting the condensation tank
• Ensure that the float inside the condensation tank is
inserted correctly.
• Ensure that the condensation tank is empty and inserted
correctly.
Connecting the power cable
• Insert the mains plug into a properly secured mains
socket.
Operation
• Avoid open doors and windows.
• After being switched on, the device operates fully
automatically.
• The fan permanently runs in dehumidification mode even
after the set nominal value has been reached until the
device is switched off.
Operating elements
23
17
22
27
24
30
25
16
21
20
12
13
14
18
19
31
32
28
26
29
15
%
No. Designation Function
2 Colour LED display
for room humidity
Indicates the current relative room
humidity by means of3different
colours
12 Child Lock button Switching the locking function on or
off
13 Child LockLED Illuminated when child lock function
is activated
14 Humidity button For setting the desired relative
humidity level
15 %/relative
humidity LED
Illuminated when the relative
humidity level is set or the current
humidity level is displayed
16
LED
Illuminated when the
dehumidification mode is selected
17
LED
Illuminated when the continuous
operation mode is selected
18
LED
Illuminated if the laundry drying
function mode is selected
19
LED
Illuminated when the ventilation
mode is selected
20 Mode button For setting the operating mode
21 On/Off LED Illuminated when the device is
switched on
To Next Page
Loading...
Need help?
General
