___________________
Specifications
TILLER
SPECIFICATIONS
Height
-
(Approximate minimum heights)
Handlebars
in
lowest
setting:
37Yt
*
Handlebars
in
highest
setting:
49)1"
*
Without
Handlebars:
33)£,'
**
* Tines resting on ground.
**
Measured from knob on
Wheelsffinesl
PTO Drive Lever to the ground.
Length
-
(Approximate minimum lengths)
With Handlebars: 60"
Without Handlebars:
5612"
Width
-
Hood width:
22J12"
Tilling width: 20"
Weight
-
(Approximate weight
of
assembled tiller
including motor oil
in
engine, but exclud-
ing gasoline
in
fuel tank and weight
of
shipping container)
7HP Recoil Start Model: 284
Ibs.
*
7HP Electric Start
Model:
310
Ibs.
*
8HP Recoil Start
Model:
296
Ibs.
*
8HP Electric Start
Model:
324
Ibs.
*
Transmission
-
Consists
of
two separate trans-
missions, the Power Unit transmis-
sion and the Tine Attachment
transmission. Both transmissions
are encased in cast iron housings
and operate
in
separate baths
of
gear oil. The housings are se-
curely connected by a locking col-
lar, a dowel pin, and two large
swing-bolts. By loosening the
swing-bolts, the Power Unit can be
disconnected from the Tine
Attachment and used as a separate
power source for optional powered
and non-powered PTO attachments.
Transmission
Gear
Oil
-
Small Top-Offs: use SAE 140,
SAE 85W-140, or SAE 80W-90.
Must have an API rating
of
GL-3,
GL-4 or GL-5.
Full Replacement: use SAE 140
or SAE 85W-140 with an API rat-
ing
of
GL-4 only.
Power Unit Gear Oil Capacity:
approximately 60 ounces. Impor-
tant-
use the oil level check hole
as your
final guide for gear oil
level correctness.
Tine Attachment Gear Oil
Capacity: approximately
12
1
/2
ounces, but use the transmission
dipstick as the
final guide.
Wheel
And
Tine
Speeds
Transmission
Gear
Oil
Capacity
-
PTO Power Unit: 60 ozs (approx.)
Tine Attachment:
12
1/
2 ozs (ap-
prox.)
Wheels-
One-piece steel;
8"
in
diameter.
Tires
-
7HP Model and 8HP Model are
equipped with 4:80 x
8"
bar tread
tires.
Recommended air pressure
is
10-to-20 pounds/square inch.
Engine
Specifications
-
Please see the engine manufac-
turer literature supplied with your
tiller for complete specifications
and details regarding the engine.
At 3000 RPM (revolutions per minute) engine speed, the wheel and tine speeds are as follows:
BELT WHEEL SPEED WHEEL TINE
POSITION
LEVER POSITION
SPEED
SPEED
Low Range Slow
.5
MPH
146 RPM
Low Range Fast 1.2 MPH 146 RPM
High Range Slow
.7
MPH 200 RPM
High Range Fast
1.72 MPH 200 RPM
65
To Next Page
