AlMA D[ILll _11"_.. Operate this unit only in a [
AIIk[__
v u n-L i x i i ni ! t._ • well: ventilated outdoor
area.confinedCarbOnarea.mOnoxde exhaust fumes can be etha n
WARNING: Avoidaccidental starting.
Make sure you are in the
starting position when pulling the starter rope (Fig. 8).
To avoid serious injury, the operator and unit must be
in a stable position while starting.
Make sure that any Add-On item is installed correctly
and secure before starting the unit.
Throttle
Control
STARTING INSTRUCTIONS
1. Mix gas with oil. Fill fuel tank with fuel/oil mixture.
See Oil and Fuel Mixing Instructions.
NOTE: There is no need to turn the unit on. The On/Off
Stop Control is in the ON ( I ) position at all times.
.........2. Fully press and release the primer bulb 10 times,
slowly. Some amount of fuel should be visible in
the primer bulb and fuel lines (Fig. 7). If you can't
see fuel in the bulb, press and release the bulb as
many times as it takes before you can see fuel in it.
Push the EZ-Start TM Lever towards the primer
bulb until it clicks and locks into place (Fig. 7).
Crouch in the starting position and do not squeeze
the throttle control (Fig. 8). Pull the starter rope out
with a controlled and steady motion until the engine
attempts to start. Repeat until the engine starts.
_ 3.
NOTE: The unit uses Advanced Starting Technology TM,
which significantly reduces the effort required to
start the engine. You must pull the starter rope out
far enough to hear the engine attempt to start.
There is no need to pull the rope briskly-- there is
no harsh resistance when pulling. Be aware that
this starting method is vastly different from (and
much easier than) what you may be used to.
5. When the engine starts, squeeze the throttle control
for 15 to 30 seconds. This will warm up the unit. The
EZ-Start TM Lever will click off automatically when
you squeeze the throttle control.
..... IF... The engine does not start, go back to step 2.
......... IF... The engine stops while you are squeezing the
throttle, go back to step 3.
IF... The engine stops before you squeeze the throttle
control, hold the throttle control and pull the starter
rope until the trimmer starts.
NOTE: If you are having trouble starting the unit or are
operating in extreme temperatures (below 40° F,
above 90° F), refer to the Troubleshooting section.
STOPPING INSTRUCTIONS
1. Release your hand from the throttle control. Allow the engine
to cool down by idling.
2. Put the On/Off Stop Control in the OFF (O) position (Fig. 6).
Primer
I
EZ-Start TM
Lever
\
\
\
Fig. 7
Starting
Position
Throttle Control j
(Do NOT squeeze during
a standard start)
Fig. 8
9
To Next Page
Loading...
Need help?
General
