What to do if wood will not split on my Troy-Bilt LS 27 Log Splitter?
If the wood won't split or splits too slowly, several factors could be at play. Make sure the pump inlet hoses are clear and unblocked. Check the oil level and, if contaminated, drain the oil, clean the reservoir, and refill. Also, avoid attempting to split wood against the grain, as this can overload the cylinder.
Why is my Troy-Bilt LS 27 cylinder shaft speed so slow?
A slow cylinder shaft speed during extension and retraction can be caused by several issues. Ensure the pump inlet hoses are clear and unblocked, and use short, large diameter inlet hoses. Check the oil level. If the oil is contaminated, drain the old oil, clean the reservoir, and refill it with fresh oil.
What to do if cylinder rod will not move on my Troy-Bilt LS 27?
If the cylinder rod isn't moving, start by checking the oil level. Disconnect the hydraulic hoses, remove any shipping plugs, and then reconnect the hoses. Ensure correct engine/pump alignment as necessary. Flush and clean the hydraulic system to clear any blockages in the hydraulic lines or the control valve.
Why is my Troy-Bilt LS 27 Log Splitter leaking pump shaft seal?
A leaking pump shaft seal could be due to several reasons. Correct the engine/pump alignment as necessary. Make certain the reservoir is properly vented.
What to do if control handle does not return to neutral on Troy-Bilt LS 27?
If the control handle doesn't return to neutral when released, it could be due to a few reasons. Try warming up the engine. If the hydraulic fluid is too thick or contaminated, replace it.
Crucial safety instructions and warnings before operating.
Procedure for unpacking and assembling the log splitter.
Filling fluids, checking tire pressure before operation.
How to properly split wood using the log splitter.
Checking and maintaining the hydraulic fluid level.
Procedure for changing the hydraulic filter and fluid.
General| Engine Displacement | 208cc |
|---|---|
| Splitting Force | 27 tons |
| Max Log Length | 25 inches |
| Beam Type | Steel |
| Orientation | Horizontal |
| Hitch Type | 2-inch ball coupler |
| Tire Size | 16 inch |
| Wedge Type | 4-way wedge |
To Next Page
