Troy-Bilt TB 27 LS - User Manual

Questions and Answers

S
stacy48Jul 31, 2025
Why wood will not split or splits too slowly on my Troy-Bilt TB 27 LS Log Splitter?
- C
  Charles MorrisJul 31, 2025
  If the wood splits too slowly or not at all with your Troy-Bilt Log Splitter, several factors could be at play. First, a small gear section or the pump check valve might be damaged, requiring attention from an authorized service dealer. Ensure the pump inlet hoses are clear and unblocked to prevent excessive vacuum. Check the oil level and, if contaminated, drain, clean the reservoir, and refill. Internal leaking in the control valve or internal cylinder damage also warrants a visit to a service dealer. Lastly, avoid splitting wood against the grain to prevent overloading the cylinder.
T
taylormartinAug 4, 2025
What to do if the cylinder rod will not move on my Troy-Bilt TB 27 LS?
- R
  Ray Everett Jr.Aug 4, 2025
  If the cylinder rod on your Troy-Bilt Log Splitter won't move, several issues could be the cause. It could be due to a broken drive shaft, set screws in the coupling not adjusted properly, damaged gear sections, a damaged relief valve, or a damaged control valve, all of which require attention from an authorized service dealer. Other potential causes include shipping plugs left in the hydraulic hoses (remove these by disconnecting and reconnecting the hoses), a loose shaft coupling (correct the engine/pump alignment), blocked hydraulic lines or control valve (flush and clean the hydraulic system), or an incorrect oil level (check and correct the oil level).
A
andre96Aug 9, 2025
Why is the cylinder shaft speed slow on my Troy-Bilt TB 27 LS?
- M
  Mary JohnsonAug 9, 2025
  If the cylinder shaft speed is slow while extending and retracting on your Troy-Bilt Log Splitter, several factors could be responsible. Damaged gear sections, a damaged relief valve, a control valve leaking internally, or an internally damaged cylinder all require attention from an authorized service dealer. Ensure the pump inlet hoses are clear and unblocked, using short, large diameter hoses to prevent excessive pump inlet vacuum. Also, verify that the engine speed is not slow. Check the oil level and replace the oil if it is contaminated, cleaning the reservoir during the process.
Z
zhansenAug 14, 2025
What to do if the control handle does not return to neutral on my Troy-Bilt TB 27 LS?
- J
  jeffreycoffeyAug 15, 2025
  If the control handle on your Troy-Bilt Log Splitter does not return to neutral when released from the forward position, the hydraulic fluid may be too cold, too thick, or contaminated; try warming up the engine or replacing the hydraulic fluid. A damaged control valve could also be the reason, requiring attention from an authorized service dealer.
R
Russell DavidsonAug 19, 2025
Why is my Troy-Bilt TB 27 LS leaking from the pump shaft seal?
- F
  fmontesAug 19, 2025
  If your Troy-Bilt Log Splitter is leaking from the pump shaft seal, the issue could stem from a broken drive shaft, damaged gear sections, a damaged shaft seal, all of which require attention from an authorized service dealer. Other potential causes include engine/pump misalignment (correct the alignment as necessary), or a plugged oil breather (ensure the reservoir is properly vented).
R
Randall SandovalAug 25, 2025
Why is my Troy-Bilt TB 27 LS cylinder leaking?
- P
  Phyllis BrayAug 26, 2025
  If your Troy-Bilt Log Splitter cylinder is leaking, this could be due to worn seals or a scored cylinder, both of which require attention from an authorized service dealer.