EasyManua.ls Logo

Troy-Bilt series 650 - User Manual

Troy-Bilt series 650
24 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
TROY-BILT LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Printed In USA
Op e r a t O r ’s Ma n u a l
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL
BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
Rear Tine Tiller — 650 Series
Form No. 769-04235
(August 11, 2008)

Table of Contents

Questions and Answers

  • A
    Amanda SpearsAug 10, 2025
    Why Troy-Bilt Tiller engine does not start?
    • S
      Steven WatsonAug 10, 2025
      If your Troy-Bilt Tiller engine doesn't start, there are several potential causes: * The spark plug wire may be disconnected; reconnect it. * The engine throttle control lever might be incorrectly set; put the lever in the START position. * The fuel tank could be empty; add fuel. * The gasoline may be stale; drain the old fuel and add fresh fuel. * The air filter might be dirty. For solutions for this cause, please consult the Engine Manual. * The spark plug may be defective or incorrectly gapped. For solutions for this cause, please consult the Engine Manual. For the following causes, please consult an Engine Service Dealer: carburetor out of adjustment, misadjusted throttle control, or dirt/water in the fuel tank.
  • S
    Stephanie PorterAug 15, 2025
    Why is my Troy-Bilt 650 engine running poorly?
    • E
      Elizabeth OliverAug 15, 2025
      If your Troy-Bilt Tiller engine is running poorly, it could be due to several reasons: * Stale gasoline: Replace it with fresh gasoline. * A defective or incorrectly gapped spark plug. For solutions for this cause, please consult the Engine Manual. * Dirty air filter(s). For solutions for this cause, please consult the Engine Manual. * Engine cooling system clogged. For solutions for this cause, please consult the Engine Manual. For the following causes, please consult an Engine Service Dealer: carburetor out of adjustment, or dirt/water in fuel tank.
  • J
    John WestAug 20, 2025
    What to do if wheels/tines will not turn on Troy-Bilt Tiller?
    • Y
      ywarrenAug 20, 2025
      If the wheels or tines on your Troy-Bilt Tiller won't turn, consider the following: * You might be using the controls improperly. Review the Operation section. * The drive belts may be worn, broken, or misadjusted. Replace or adjust the belts. * A bolt may be loose in the transmission pulley. Tighten the bolt. * Internal transmission wear or damage may have occurred. Contact a local dealer or the factory.
  • R
    rmasseyAug 26, 2025
    Why is my Troy-Bilt 650 engine overheating?
    • J
      jennifer87Aug 26, 2025
      If your Troy-Bilt Tiller engine overheats, the following could be the cause: * Low oil level. For solutions for this cause, please consult the Engine Manual. * Engine cooling system clogged. For solutions for this cause, please consult the Engine Manual. For the following causes, please consult an Engine Service Dealer: carburetor out of adjustment.
  • S
    Sara BurnsAug 30, 2025
    What to do if tines turn, but wheels don’t on Troy-Bilt 650 Tiller?
    • C
      Christopher HartmanAug 30, 2025
      If the tines on your Troy-Bilt Tiller turn, but the wheels don’t, check these: * The wheel drive pins may not be properly inserted. Insert the drive pins properly. * A bolt may be loose in the transmission pulley. Tighten the bolt. * Internal transmission wear or damage may have occurred. Contact a local dealer or the factory.
  • W
    Whitney RiggsSep 4, 2025
    What to do if wheels turn, but tines don’t on Troy-Bilt 650?
    • V
      vgoldenSep 5, 2025
      If the wheels on your Troy-Bilt Tiller turn, but the tines don’t, examine these: * The tine holder mounting hardware may be missing. Replace the hardware. * A bolt may be loose in the transmission pulley. Tighten the bolt. * Internal transmission wear or damage may have occurred. Contact a local dealer or the factory.

Troy-Bilt series 650 Specifications

General IconGeneral
BrandTroy-Bilt
Modelseries 650
CategoryTiller
LanguageEnglish

Related product manuals