How to fix Troy-Bilt TB4620CC Chainsaw that won't start?
If your Troy-Bilt Chainsaw won't start, ensure you are following the correct starting procedures. A fouled spark plug could also be the culprit, so try cleaning, gapping, or replacing it. If the carburetor mixture is incorrectly adjusted, have it adjusted by an Authorized Service Center.
Why Troy-Bilt TB4620CC starts but has low power?
If your Troy-Bilt Chainsaw starts but the engine has low power, start by replacing the fuel filter. Ensure the lever is in Position 3. Also, a dirty spark arrester screen or air filter can cause low power, so replace the spark arrester screen and remove, clean, and reinstall the air filter. If these steps don't solve the problem, the carburetor mixture adjustment setting may be incorrect, and you should have it adjusted by an Authorized Service Center.
Why Troy-Bilt Chainsaw smokes excessively?
If your Troy-Bilt Chainsaw smokes excessively, it might be due to an incorrect carburetor mixture adjustment setting; in this case, have it adjusted by an Authorized Service Center. Another potential cause is an incorrect fuel mixture. Ensure you are using properly mixed fuel (40:1 mixture).
What to do if Troy-Bilt TB4620CC Chainsaw engine hesitates?
If your Troy-Bilt Chainsaw engine hesitates, the carburetor mixture adjustment setting may be incorrect. Have the carburetor adjusted by an Authorized Service Center.
Why Troy-Bilt TB4620CC runs erratically?
If your Troy-Bilt Chainsaw runs erratically, the spark plug may be incorrectly gapped. Try cleaning, gapping, or replacing the plug.
What causes Troy-Bilt Chainsaw to have no power under load?
If your Troy-Bilt Chainsaw has no power under load, the carburetor mixture adjustment setting may be incorrect. Have your carburetor adjusted by an Authorized Service Center.
Detailed warnings and preventative measures against kickback hazards.
Detailed explanation of rotational and pinch kickback dangers.
Proper ratio for mixing oil and gasoline, and precautions for fuel types.
Step-by-step guide to start the chainsaw engine.
Techniques and safety precautions for felling trees.
How to adjust chain tension and test the chain brake function.
Diagnosing and fixing issues related to starting and low engine power.
General| Engine Type | 2-Cycle |
|---|---|
| Engine Displacement | 46 cc |
| Bar Length | 20 inches |
| Chain Gauge | 0.050 inches |
| Warranty | 2 years |
| Chain Pitch | 0.325 inches |
To Next Page
