To Next PageTo Next Page
Need help?Do you have a question about the Troy-Bilt TB75SS and is the answer not in the manual?
Engine Specifications| engine type | Air-Cooled, 2-Cycle |
|---|---|
| stroke | 1.25 in. (31.75 mm) |
| displacement | 1.9 cu in. (31 cc) |
| idle speed | 2, 800 - 4, 000 rpm |
| operating RPM | 7, 200+ rpm |
| spark plug gap | 0.020 in. (0.5 mm) |
| fuel/oil ratio | 40:1 |
| fuel tank capacity | 13 oz. (384 ml) |
Drive Shaft & Cutting Attachment| approximate unit weight | 13 lbs. (6 kg) |
|---|---|
| line spool diameter | 3 inches (76.2 mm) |
| trimming line diameter | 0.095 inches (2.41 mm) |
| cutting path diameter | 17 inches (43.18 cm) |
Instruction to thoroughly read and understand the manual before use.
Specific safety precautions for handling gasoline and fueling the trimmer.
Safe operating procedures and precautions to follow during use.
Additional safety advisories for storage, transport, and general precautions.
Explanation of safety symbols and pictographs used in the manual.
Common uses and tasks the trimmer is designed for.
Procedure for attaching and positioning the D-handle for optimal grip.
Detailed instructions on the proper ratio of oil to gasoline for the 2-cycle engine.
Explanation of blended fuels and precautions when using them.
Recommended practices for using blended fuels to prevent issues.
Advice on using fuel additives to improve engine performance and longevity.
Step-by-step guide to start the trimmer engine, including primer and EZ-Start.
Method for safely shutting down the trimmer engine.
Information on using the EZ-Link system for attaching accessories.
Procedure for detaching cutting attachments and accessories.
Procedure for attaching cutting attachments and accessories.
Correct posture and grip for operating the trimmer.
Method for extending the trimmer line using the bump head.
Advice for efficient and effective trimming techniques.
Technique for performing decorative trimming around objects.
Recommended maintenance tasks and their frequencies.
Instructions for installing trimming line into the cutting head.
Specific steps for installing single trimming line.
Specific steps for installing split-line trimming line.
Method for installing a pre-wound spool of trimmer line.
Procedures for maintaining the air filter for optimal engine performance.
Detailed steps for cleaning and re-oiling the air filter.
Procedure for reattaching the air filter/muffler cover after maintenance.
Steps for inspecting, cleaning, and maintaining the spark arrestor.
Instructions for adjusting the carburetor for proper engine idling and performance.
Guide for removing, checking, and replacing the spark plug.
Procedure for preparing the trimmer for extended storage.
Guidelines for safely transporting the trimmer.
How to clean the exterior of the trimmer unit.
Recommendations for storing the trimmer unit safely.
Diagnosing and fixing issues preventing the engine from starting.
Troubleshooting problems related to the engine not idling correctly.
Resolving issues where the engine fails to accelerate properly.
Addressing problems with reduced engine power or stalling during operation.
Troubleshooting why the trimmer line is not feeding out.
Resolving issues with the trimmer line feeding out excessively.
Specifications related to the engine's type, displacement, and performance.
Specifications for the drive shaft, cutting head, and line.
Details on the owner's responsibilities and rights under the warranty.
Specific duties of the owner regarding maintenance and warranty claims.
Overview of what is covered by the manufacturer's warranty.
Instructions on how to get warranty service and find authorized dealers.
Exclusions from the limited warranty coverage.
Warranty limitations for products sold outside the US.
