5
These are activated by a short press of the button. The secondary functions ‘Reset’
and ‘Formula’ are activated by holding the button down until the function
operates. When the unit is first switched on, the display will show the current
formula in use and the calculated kg DM/ha based on that formula, and any
readings in memory. Pressing the “Height” button will briefly display the average
pasture height. This is often referred to as “clicks” (measured in 0.5 cm) and will
be displayed to one decimal place (i.e. 0.0 or 12.4).
The number of readings is displayed when the ‘Count’ button is pressed. The
display will show a ‘c’ on the left side and the count on the right. The display will
return to normal after two seconds.
All readings can be cleared (reset) by holding down the “Reset” button for
approximately two seconds, then the display will change to “0”.
To Next Page
Loading...
