Need help?Do you have a question about the TruAudio T100 and is the answer not in the manual?
Controls amplifier output volume via IR remote or fixed at 95%.
Allows setting up or learning IR commands for remote control functionality.
Determines if speakers play full stereo or mono audio channels.
Sets speaker output to full range (20Hz-20kHz) or high-pass filtered at 80Hz.
Selects default input source between Analog RCA (IN 1) and Digital Toslink (IN 2).
For service use only; should remain off for normal operation.
Guide for connecting the T100 amplifier to a TV and subwoofer system.
Detailed steps for programming the T100 to learn IR commands from a TV remote.
Essential precautions for safe and proper operation of the amplifier.
Details on the limited 5-year warranty for subwoofers and electronic products.
General| Channels | 2 |
|---|---|
| Impedance | 4-8 Ohms |
| Signal to Noise Ratio | >100dB |
| Total Harmonic Distortion | <0.1% |
| Input Sensitivity | 1V |
| Gain | 32dB |
| Input Impedance | 22k Ohms |
| Dimensions | 17" x 3.5" x 14" (431.8 x 88.9 x 355.6mm) |
| Weight | 24.2 lbs (11 kg) |
| Signal-to-Noise Ratio | >100dB |
| Watts per channel @ 8 Ohms | 100W |
| Watts per channel @ 4 Ohms | 150W |
| Frequency Response | 20Hz-20kHz |
To Next Page
