IMPORTANT SAFEGUARDS
At True & Tidy, safe performance is our top
priority with any consumer product, so that you can use and trust our products
confidently. Please use and operate product with due care and attention placed
on the following operating instructions and precautions.
Carefully read all instructions before operating the steam mop for the first time.
This appliance is not intended for use by children or persons with physical, mental or
sensory capabilities, or lack of experience and knowledge without the supervision or
instruction concerning the use of the appliance by a person responsible for their
safety.
Ensure the steam mop is properly assembled before use.
Only use attachments or accessories provided and specified in this instruction
manual.
Do not place the appliance in the same spot for more than 10 seconds to avoid
damage from heavy heating.
Never use the appliance without the mop pad.
Allow the steam mop to cool down completely before storing.
Store the appliance indoors in a cool, dry place.
Do not touch the bottom of the appliance during operation.
Do not leave appliance unattended while it is in operation or connected.
Do not use steam mop if it shows visible signs of damage or if there is leaking.
Do not use the appliance if the power cord is damaged.
Do not tilt or turn the appliance over when in use. Only use on flat, horizontal
surfaces.
Do not fill the water tank with hot water or corrosive cleaning agents. Distilled or
filtered water is strongly recommended.
Only connect to 120V power outlet.
Do not use on any unsealed hard floor surfaces. Additionally, on surfaces that have
been treated with wax or some no-wax floors, the sheen may be removed by the
heat and steam action. It is always recommended to test an isolated area of the
surface to be cleaned before proceeding. We also recommend end that you check
the use and care instructions from the floor manufacturer.
Do not immerse the appliance, plug, or power cord in water to reduce the risk of
electric shock.