USING YOUR STEAM MOP
1. Remove the
Water Tank
Press down on
the water tank
release button
and gently
remove the water
tank.
2. Open the water
tank by unscrewing
the water tank cap.
3. Fill the water tank with
water. Screw the water cap
back on and insert water tank
in to the body of the steam
mop.
FILLING THE WATER TANK
POWERING ON YOUR STEAM MOP
Plug in the appliance. Since this is a powerful 1500 watt appliance,
please make sure your outlet and circuit can handle the wattage.
Press the On/Off Power Button. The indicator lights will turn red, it
indicates preheating. If the lights does not illuminate, please check
the "troubleshooting" section for more details.
The appliance warm-up time is 25seconds. When steam mop is ready
to steam the indicator lights will turn blue.
Adjust the level of steam to your desired amount. Max is suggested
for heavy duty tile and carpet. Min is suggested for fabricated and/or
coated surfaces such as vinyl or laminate.
1.
2.
3.
4.
To Next Page
Loading...
Need help?
General
