Install Burner Heads
• Ensure the tabs on burner head are aligned and inserted into notch of the burner base on
cooktop. Assemble center burner, when used as shown in Fig-6.
• Grate is set by positioning the legs on the burner base holder.
• All burner caps and burner bases should be properly installed BEFORE operating the cooktop.
• Always match the burner head size to the cap size.
• Always line up the hole in the burner head to the electrode.
It's very important to check that the burner flame distributor (F) and the cap (C) are correctly
repositioned. Failure to do so can cause serious problems. Also, check if the Electrode (E) &
Thermocouple (T) are clean to ensure trouble-free sparking.
To Next Page
Loading...
Need help?
General
