True CS800 Assembly Instructions

Assembly Instructions
12
TV TUNER PROGRAMMING
Analog (NTSC) and Digital (ATSC) Tuner
(Not applicable for Model PS850 Touchscreen without TV Tuner)
INITIAL STEPS
1. If you have not already reviewed and completed the necessary requirements for:
a) Treadmill Operation on Page 4 or
b) Bike and Elliptical Operation on Page 9
please complete these steps at this time if you have not already.
2. Connect video signal source into COAX connector on bottom of exercise equipment.
3. Check that equipment power cord is plugged into wall outlet and where applicable the power switch is
set to ON (1 on toggle switch).
4. Allow display to fully light up. Allow a little over a minute for display to fully light up.
ENTERING TV TUNER SETUP
5. The HOME screen will appear as shown below:
6. Press and hold the upper left corner of HOME screen for about 5 seconds until the logo
on HOME screen begins to flash on and off. Stop pressing left corner. See HOME screen image below.
7. Then press and hold, for about 5 seconds, the MANUAL WORKOUT key in the bottom right corner of
the HOME screen.
The MAINTENANCE screen will appear at this point.
8. The MAINTENANCE screen will appear
as shown here.
Press the UTILITIES key on the MAINTENANCE
screen.
STEP 6:
PRESS AND
HOLD HERE
STEP 7:
PRESS AND
HOLD HERE
WILL FLASH

True CS800 Specifications

General

Brand	True
Model	CS800
Category	Exercise Bike
Language	English