CHAPTER 2: ASSEMBLY INSTRUCTIONS
BIKE ASSEMBLY STEPS (continued):
Step 6 Seat Cushion:
• For each screw (#140) insert through quantity 1 split washer (#142) then 1 flat washer (#141)
• Place the Seat Cushion onto the top of the Seat Carriage
• Insert each screw assembly (quantity 4) through the sides of the Seat Cushion bracket, into the sides of the Seat
Carriage
• Tighten using the provided 4mm hex wrench
Step 7 Seat Back:
• For each screw (#170) insert through quantity 1 split washer (#142)
• Align the Seat Back holes with the Seat Back Frame holes
• Insert each screw assembly (quantity 4) through the Seat Back Frame tube, into the Seat Back
• Tighten using the provided 5mm hex wrench
Step 8 Seat Back Cover:
• Align posts on the plastic Seat Back Cover with the mating features on the Seat Back
• Snap the Seat Back Cover onto the Seat Back
Truefitness.com / 800.426.6570 / 636.272.7100 12
To Next Page
Loading...
