CHAPTER 2: ASSEMBLY INSTRUCTIONS
BIKE ASSEMBLY STEPS (continued):
Step 9 Water Bottle Holder:
• Place Water Bottle Holder Top onto the
Handlebar tube (as shown, left)
• Align the Water Bottom Holder Bottom
component with the Water Bottle Holder Top
component
• Insert each screw (#129, quantity 6) through the
Water Bottle Holder Bottom component and
Handlebar tube, into the Water Bottle Holder
Top component
• Tighten using Phillips head screwdriver (not
provided)
Step 10 Front Mast Preparation:
• Insert Bottom Console Cover onto the Front
Mast Tube (as shown, left)
• Insert Mast Boot onto the Front Mast Tube
(as shown, left)
• Verify that the Bottom Console Cover and
Mast Boot are in the correct orientation (as
shown, left)
Truefitness.com / 800.426.6570 / 636.272.7100 13
To Next Page
Loading...
