True SPL1000 - Commercial Maintenance Schedule; Compliances

10
COMMERCIAL MAINTENANCE SCHEDULE
Commercial Maintenance Schedule
Daily Weekly Monthly 6 Months Annually
Inspect cables for wear, tension, and proper
connection if equipped. Replace at the fi rst sign of
wear.
X
Inspect cable length and cable end fi ttings.
Replace at the fi rst sign of wear.
X
Inspect all nuts and bolts and tighten if needed. X
Inspect safety catches, stop rods, and their
fasteners. Replace at the fi rst sign of wear.
X
Inspect all anti-slip surfaces and replace as
needed.
X
Inspect all adjustment pins, weight stack pins,
set screws, gas shocks, snap links, and pulleys if
equipped.
X
Inspect all accessory bars and handles. X
Inspect all safety and instructional decals. X
Inspect all weight stack shields if equipped. X
Clean guide rods and lubricate with a tefl on
lubricant if equipped.
X
Clean upholstery. X
Lubricate pivot bearings and linear bearings. X
Replace cables if equipped. X
COMPLIANCES
This equipment complies with all applicable codes and regulations. For a complete list of compliances, please visit
www.truefi tness.com.