Assembly
Use the t-handle with the allen key
to loosen the bolts on the right side
of the treadmill. Make sure they are
screwed out even with each other.
Take the right side rail and pull the
wire through the base that attaches to
the treadmill. Feed this wire through
the hole in the base of the treadmill.
Slip the right side rail onto the 4 bolts
that you have loosened.
Now onto the left side of the treadmill.
Loosen the 4 bolts, as you did on the
other side.
Slip side rail onto the 4 loosened
bolts.
01 02
05
Connect the wires from the right side
rail to the wires in the treadmill as
shown above.
0403
06
08
TRUEFORM RUNNER
To Next Page
Loading...