Truma Aventa compact - Accessories; Air Filter Kit; Control Systems and Connectivity; Troubleshooting

7EN
Troubleshooting
Fault Cause / Remedy
Appliance not cooling – Thawing procedure in progress
– Remote control temperature
setting reached or too high
Appliance providing in-
sufficient cooling or no
cooling at all
– Filter / panels dirty, replace
filter/clean panels
– External air routes soiled /
blocked
Moisture on underside
of air distributor
– Close windows and doors and
select high fan level
Water dripping out of
air distributor
– Condensation trap on external
unit blocked
– Seal between appliance and
roof not intact
– System at too much of an angle
Remote control
not working
– Check batteries in remote con-
trol and replace if necessary
Appliance not react-
ing to remote control
commands
– Check whether there are ob-
structions between the remote
control and the IR receiver
– Is the remote control tuned to
the IR receiver / Tune remote
control to IR receiver.
Compressor switches
off and back on again
after approx. 3 minutes
– Voltage drop at 230V
power
supply / check 230V
power
supply
If these actions do not remedy the problem, please con-
tact Truma Service.
Accessories
Aventa air filter kit, 2 pcs
for air distributor, not for air distributor small
(Part. No. 40091-16800)
Figure 5
Truma CP plus
Truma CP plus digital control panel with automatic climate
control for the iNet-capable Truma heaters Combi and
Truma air conditioning systems Aventa eco, Aventa comfort
(from serial number 24084022 – 04/2013), Saphir comfort RC
and Saphir compact (from serial number 23091001 – 04/2012)
– The automatic climate control function automatically con-
trols the heater and the air conditioning system until the
required temperature is reached in the vehicle.
– Can be extended with the TrumaiNet Box. With this, all
TIN bus-capable Truma appliances can also be controlled
via the Truma App
Figure 6
Truma iNet Box
The Truma iNet Box for simple networking and control of
Truma appliances with a smartphone or tablet computer using
the app.
– Simple installation and start-up via the Truma App
– Can be extended with the update function, which ensures
that it is always up to date
Figure 7