Need help?Do you have a question about the Truma Combi Series and is the answer not in the manual?
Indicates possible hazards.
Contains important information and tips.
Appliance approved for installation and operation in a vehicle.
Read carefully, follow and keep for later use.
Instructions on how to act if gas is detected.
Lists prohibited uses and applications.
Safety precautions when working inside the installation compartment.
Warnings about potential electrical hazards and explosion risks.
Advice on avoiding cuts from sharp edges.
Ensuring safe operation with Truma control panels.
Details responsibilities for appliance operation and water.
Guidelines for operating the appliance while the vehicle is moving.
Guidance for resolving common issues with the appliance.
Warnings about fire and explosion risks from damaged appliances.
Emphasizes the need for expert repair of faults.
Instructions for self-repair based on the guide.
Procedure after a misfire requires expert inspection.
Guidelines for maintaining, repairing, and cleaning the appliance.
Details operation for the Combi E model.
Appliance automatically selects temperature based on settings.
For heating water, appliance uses gas or 230 V ~ electric.
Combines gas and electric modes for heating.
Control panels are described in separate operating instructions.
Location and function of the room temperature sensor.
Information on the FrostControl safety/drain valve.
Procedure for opening the safety/drain valve.
Procedure for closing the safety/drain valve.
Explanation of the automatic valve opening mechanism.
Specific instructions for the UK version drain valve.
Instructions for filling the appliance's water container.
Instructions for draining the water container.
Procedure for starting the Combi appliance.
Specific start-up for Combi (E) model with control panel.
Information about fuse types and replacement.
Details on the 12V fuse and its replacement.
Information on the 230V fuse for Combi E models.
Procedure for switching off the appliance.
General guidelines for maintenance, repairs, and cleaning.
Tasks requiring professional inspection and cleaning.
User-performed maintenance and checks.
Recommendations for cleaning and care products.
Considerations when using the appliance with solar systems.
Detailed specifications determined by EN 624 or Truma.
Specifies the type of gas used (propane/butane).
Details the operating pressure and type plate information.
Indicates the water capacity of the boiler.
Provides heating times from 15°C to 60°C.
Specifies the maximum pump pressure.
Details the maximum system pressure.
Lists heat output in gas, electric, and mixed modes.
Specifies gas consumption rates for different models.
Details standby heat consumption in gas mode.
Provides data required by EN 624 standards.
Lists countries where the appliance is approved for use.
Details the mechanical overheating protection switch.
Procedure to reset the overheating protection.
Specifies air flow rates for different warm air outlet configurations.
Details 12V power consumption for heater and boiler.
Details 230V power consumption for different models.
Specifies the appliance's protection type (IP 21).
Provides weight specifications for heater and periphery.
Illustrates the physical dimensions of the appliance.
Appliance must be disposed of according to administrative regulations.
Describes fault causes found in control panel instructions.
Refers to troubleshooting guide for water supply faults.
Guide for resolving water supply related errors.
Lists available accessories for Truma appliances.
Digital control panel with automatic climate control.
Box for networking and controlling appliances via smartphone.
Analogue control panel (not for Combi E).
Heating element with connector cable and retaining bracket.
Control panel cables in various lengths.
Details the warranty coverage for material and manufacturing defects.
Lists circumstances under which warranty claims are not applicable.
Procedure for claiming warranty service from Truma.
To Next Page
General
