Need help?Do you have a question about the Truper SICI-7-1/4A and is the answer not in the manual?
Maintain a clean, well-lit work area. Keep bystanders at a safe distance.
Use correct plugs, avoid wet conditions, and keep cords away from heat and sharp edges.
Stay alert, wear PPE, and ensure the tool is switched off before connecting or carrying.
Use appropriate tools for tasks, avoid forcing, and disconnect power before adjustments.
Check for alignment, repair damage before use, and keep cutting accessories sharp.
Use maintained discs, hold firmly, and align disc correctly to prevent kickback.
Keep hands clear of cutting path, secure workpiece, and verify guard functionality.
Step-by-step guide for installing the cutting disc, ensuring proper orientation and secure fastening.
Connect plug, unblock switch, and press to start disc rotation. Release switch to stop.
Set desired cutting depth using the adjustment knob, matching workpiece thickness.
Adjust the saw for bevel cuts from 0° to 45° using the angle adjustment knobs.
Learn to use the guide arm for cutting widths and adjust its position as needed.
Instructions for replacing worn carbon brushes to ensure motor performance and tool longevity.
Maintain a clean, well-lit work area. Keep bystanders at a safe distance.
Use correct plugs, avoid wet conditions, and keep cords away from heat and sharp edges.
Stay alert, wear PPE, and ensure the tool is switched off before connecting or carrying.
Use appropriate tools for tasks, avoid forcing, and disconnect power before adjustments.
Check for alignment, repair damage before use, and keep cutting accessories sharp.
Use maintained discs, hold firmly, and align disc correctly to prevent kickback.
Keep hands clear of cutting path, secure workpiece, and verify guard functionality.
Step-by-step guide for installing the cutting disc, ensuring proper orientation and secure fastening.
Connect plug, unblock switch, and press to start disc rotation. Release switch to stop.
Set desired cutting depth using the adjustment knob, matching workpiece thickness.
Adjust the saw for bevel cuts from 0° to 45° using the angle adjustment knobs.
Learn to use the guide arm for cutting widths and adjust its position as needed.
Instructions for replacing worn carbon brushes to ensure motor performance and tool longevity.
To Next Page
General
