Need help?Do you have a question about the TruSens Z-3000 and is the answer not in the manual?
General| Timer | Yes |
|---|---|
| Noise level | 60 dB |
| Air purify rate | - m³/h |
| Number of speeds | 5 |
| Noise level (low speed) | 30 dB |
| Timer duration (maximum) | 12 h |
| Timer duration (minimum) | 2 h |
| Suitable for room area up to | 70 m² |
| Placement | Floor |
| Control type | Touch |
| Display type | LCD |
| Product color | White |
| AC input voltage | 120 V |
| AC input frequency | 60 Hz |
| Power consumption (max) | 68 W |
| Filtering capability | Allergens, Dust mites, Pollen |
Weight and Dimensions| Width | 263 mm |
|---|---|
| Height | 726 mm |
| Weight | 6000 g |
Remote air quality monitor that ensures cleaner air, right where you need it.
Two airflow streams move air effectively and comfortably throughout the room.
Colour-coded illuminated ring provides additional information by communicating air quality in real-time.
DuPont™ HEPA filter captures pollutants and VOC gases/odours. UV light kills germs and bacteria trapped in the filter.
Exceptional functionality wrapped in a contemporary design that fits any environment.
Plug in your SensorPod and air purifier, place them in the room, and power on the unit.
The purifier adjusts fan speeds based on air quality readings from SensorPod for optimal performance.
Select fan speed or AUTO mode. AUTO mode adjusts fan speed based on air quality readings from SensorPod.
Turns off display illumination for use while sleeping without sacrificing purifier effectiveness.
Purifier automatically turns off after 2, 4, 8, or 12 hours. Press button to cancel countdown.
UV bulb is on when symbol is white. Symbol glows red when it's time to replace the UV bulb.
Resets indicators for HEPA, Carbon, and UV filters after replacement.
SensorPod measures particulate matter to calculate overall air quality, displayed via color-coded indicators.
Displays air quality as Good (Blue), Moderate (Yellow), or Poor (Red) with numeric values.
Steps to power off the purifier, place it on its side, and remove the filter chamber cover.
Guide to replacing the HEPA filter drum, securing it, and resetting the indicator.
Instructions for replacing the carbon layer, including pre-filter handling and indicator reset.
Recommendation to inspect and wash the prefilter monthly or with carbon filter changes.
Steps to replace the UV bulb, including removing housing, disconnecting, and resetting the indicator.
Instructions to clean the SensorPod's viewing chamber and dust sensor lens every 1-2 months.
Optimal placement for the SensorPod for accurate air quality measurement within the room.
Guidance on how often to replace Carbon, HEPA filters, and UV bulb based on usage.
Recommendation to inspect and wash the prefilter monthly or every time the carbon filter is replaced.
Recommendation to clean the dust sensor within the SensorPod every 1-2 months for accuracy.
Troubleshooting steps for when the purifier fails to power on, checking connections and filter fit.
Troubleshooting tips for Auto Mode, off air quality indicators, or blinking sensor signal.
Guidance on contacting support to order a replacement SensorPod and pairing instructions.
Step-by-step instructions to repair the connection between the SensorPod and the purifier.
Details the 2-year limited warranty, exclusions, and consumer rights under Australian/New Zealand law.
Lists conditions and damages that are not covered by the product warranty.
Instructions on how to submit a warranty claim, including required proof of purchase.
Information on how to get assistance, visit the website, email, or call customer support.
To Next Page
