TRUST BT446 WIRELESS BLUETOOTH TABLET
6
8 Troubleshooting
8.1 Replacing the point of the pen
When the point of the pen becomes worn, it can be replaced with one of the two
spare points which are supplied with the device.
1. Hold the pen firmly and carefully pull the point of the pen out of the pen
using the metal pen point remover.
2. Carefully insert the new point into the pen.
3. The pen is now ready for use.
8.2 FAQs (Frequently Asked Questions)
Method
1. Read the solutions given below.
2. Check for up-to-date FAQs, drivers and instruction
manuals on the Internet (www.trust.com/14117).
Problem Cause Possible solution
Does the tablet
work with other
(drawing)
programs?
The mouse function always
works, although the pressure
sensitivity is not supported
by all drawing programs
(contact the manufacturer of
the program).
The indicator on the
tablet does not light
up.
The connection has been
broken.
Turn the tablet off for at
least 3 seconds and then
turn it back on.
The pen arrow
shakes.
The tablet has been placed
too close to the monitor
causing interference.
Position the tablet further
away from the monitor.
The batteries have been
inserted incorrectly.
Reinsert the batteries (see
chapter 1.1).
The pen does not
do anything.
The battery is empty. Replace the battery
(see chapter 1.1).
The pen only works
in the relative mode
whilst the absolute
mode has been
selected.
The point of the pen is worn.
Replace the point of the pen
as described in chapter 8.1.
The pen reacts too
slowly or too
quickly.
The pen’s sensitivity has not
been set correctly.
Adjust the pen sensitivity
(see chapter 5.2).
The mouse buttons
do not work or do
not work correctly.
The pen has not been
configured correctly which
causes the mouse to not
To Next Page
Loading...
