Trust Easy Scan 19200

Questions and Answers

T
Tracy MurphyJul 27, 2025
What to do if I get an error message during scanning with my Trust Easy Scan 19200?
- M
  Madeline CampbellJul 27, 2025
  If you encounter an error message during scanning with your Trust Scanner, it could be due to several reasons. First, ensure that your hard disk has sufficient free space; you need approximately three times the image size as free space. If space is limited, free up space or choose a lower resolution. Also, when scanning an A4 format in color, select a maximum resolution of 300 dpi. For small originals (1.3 x 1.3 cm), only select a resolution above 1200 dpi.
A
Angela SandersAug 2, 2025
Why is the scan quality poor on my Trust Scanner?
- V
  Victoria MillerAug 2, 2025
  If your Trust Scanner is producing poor quality scans, there are a few things to check. Ensure that the resolution in the TWAIN driver is set to at least 300 dpi. Also, verify that your display adapter is set to a minimum of 65,536 colors. Finally, a dirty glass plate can cause poor scans, so be sure to clean it.
C
cochrancarlaAug 8, 2025
How to fix a too dark scan on my Trust Easy Scan 19200?
- T
  Tina NicholsAug 8, 2025
  If your Trust Scanner is producing scans that are too dark, there are a few potential causes. The scanner may not be fully warmed up, so allow it a few minutes to warm up before scanning. Your monitor brightness could also be a factor, so try adjusting it. Additionally, check the brightness settings in the TWAIN driver and adjust them as needed.
L
Laura RosalesAug 14, 2025
Why is my Trust Scanner working so sluggishly?
- M
  Michael CurtisAug 14, 2025
  If your Trust Scanner is working sluggishly, it could be due to several factors. Consult your computer or motherboard's user guide for instructions on how to set the printer port to EPP in the BIOS. High resolutions should only be used for small originals, and normally 300 dpi is sufficient for an image or text. Ensure that your system meets the minimum memory requirements: 8MB is necessary, 16 MB is recommended for Windows 3.1x, and 32 MB for Windows 95.
M
matthewruizAug 21, 2025
What to do if the printer is not responding when connected to my Trust Easy Scan 19200 Scanner?
- M
  Michelle HarmonAug 21, 2025
  If your printer is not responding when connected through the Trust Scanner, it might be due to a few reasons. The scanner’s printer connection can sometimes have problems with certain printers, and adding a separate printer card is recommended. Ensure that the scanner is properly connected to the mains. If your printer operates according to the GUI principle, using a separate printer card and connecting the printer directly to the parallel port for printing is advisable.