Secure Web Gateway 11.5 Setup Guide
Copyright © 2013 Trustwave Holdings, Inc. All rights reserved. 12
4 Performing Additional Configuration
You can optionally use the commands of the Limited Shell to manage the functionality and monitor the
appliance.
Each appliance has different configuration needs, so there is no set procedure. Enter the relevant Limited
Shell commands and values.
Limited Shell commands are divided into two categories; Configuration commands and Monitoring
commands.
This section contains the following:
• Limited Shell Commands — Summary List
• Limited Shell Configuration Commands
• Limited Shell Monitoring Commands
4.1 Limited Shell Commands — Summary List
The following monitoring and configuration commands are available:
Note: The A/C/M column indicates if the command is an Administration (A), Configuration(C), or
Monitoring (M) command.
For more information on configuring the system, refer to Limited Shell Configuration Commands.
For further in-depth analysis and diagnostics of the system, refer to Limited Shell Monitoring Commands.
Command
A/C/M
Description
access_list
C
Enables/disables access list
arp
M
Displays the arp table
change_password
C
Change password
check_connectivity
M
Checks connectivity to the remote devices (for Policy Server or All-
in-One appliances)
config_ ...
C
Network or service configuration. Double tab to view the
config_network, config_time, config_hardware,
config_upgrade, config_support, config_psweb,
config_exclude, config_bridge, and config_access_log
commands.
To Next Page