Trustwave SWG 3000 - 1 Before You Begin; 2 Installing the Appliance; Installing a Physical SWG Appliance

To Next Page

To Previous Page

Secure Web Gateway 11.5 Setup Guide

1 Before You Begin

Note: Physical SWG appliances come with the required image already loaded. Should you need to reload

or replace the image, refer to SWG Installation Utility on page 22.

You should perform the following tasks in the order listed:

1. Installing the Appliance

2. Setting Up the Appliance

3. Performing Additional Configuration

After you have set up the appliance, you can configure the system according to your needs. For

instructions, see the

Management Console Reference Guide

2 Installing the Appliance

This section contains the following:

• Installing a Physical SWG Appliance

• Deploying a Virtual SWG from an OVF File

2.1 Installing a Physical SWG Appliance

Installation consists of connecting to the appliance. You can connect in any of the following ways:

• Using an Ethernet cable

• Using a Serial cable (SWG 3000 and SWG 5000 only)

• Using a keyboard and monitor

Instructions for connecting are provided on the following pages. Before connecting to the appliance,

ensure that the following requirements are satisfied.