Tsun TSOL-MS800 Quick Installation

Microinveer Installation
Installation Steps
Step 1. Make an installation map
Step 2. Fix the microinveer.
Step 3. Connect the AC cable of two microinveers
DANGER
CAUTION
MICROINVERTER
Quick Installation
When choosing the position of installation, comply with the following
conditions:
Take out the SN labels and installation map from the package. Paste
the SN labels on the installation map as below and complete the
information of the solar plant.
TSOL- MS400/MS350/MS300
TSOL- MS800/MS700/MS600
Choose an installation position. Using two pairs of screws and nuts
to x the microinveer on the frame. Make sure that the label of
microinveer should be upside.
Eve micro-inveer could be connected to the other one by its
AC cables.
Plug the female AC connector of one microinveer into a male AC
connector of another micro-inveer to form a continuous AC
branch circuit.
Use Nylon cable ties to x the AC cables onto the frame.
Use a Connector Protective Cap to make sure the unused AC
connector to be closed.
· To avoid unwanted power derating due to an increase in the
internal temperature of the inveer, do not expose it to direct
sunlight.
· To avoid overheating, always make sure the ow of air around the
inveer is not blocked.
· Do not install in places where gasses or ammable substances
may be present.
· Avoid electromagnetic inteerence that can compromise the
correct operation of electronic equipment.
· It’s recommended to install microinveer on structures under-
neath the photovoltaic modules so that they work in the shade.
· Use a mobile phone to check the Wi-Fi signal strength at the
installation position. If the Wi-Fi signal is bad, t to install the
microinveer at another position or move the Wi-Fi router.
·Only qualied personnel should install, troubleshoot, or replace TITAN
micro inveers or the cable and accessories.
·Before installation, check the unit to ensure absence of any transpo
or handling damage, which could aect insulation integrity or safety
clearances.
·Unauthorized removal of necessa protections, improper use,
incorrect installation and operation may lead to serious safety and
shock hazards or equipment damage.
·Be aware that installation of this equipment includes risk of electric
shock.
·If there are more than one installation site, please make the
installation map separately and give a clear description about the
installation site.
·The row of the table corresponds the shoer side of PV module and
the column of the table corresponds the longer side of PV module.
The direction on the upper left corner means the actual installation
orientation.
DANGER
WARNING
CAUTION
·Do not install the equipment in adverse environment conditions such
as ammable, explosive, corrosive, extreme high or low temperature,
and humid.
·Choose installation location carefully and adhere to specied cooling
requirements. Micro-inveer should be installed in a suitable position
with good ventilation and no directly sunshine.
·There are no screws and nuts in the package.
·The distance between eve two micro-inveers should meet the
length of AC cables. The length of AC cables are shown as below:
WARNING
·According to the max current of the AC cables, there is a max
installation quantity for the micro-inveer in each cable section.
Model
Model
TSOL-MS800
TSOL-MS700
TSOL-MS600
TSOL-MS400
TSOL-MS350
TSOL-MS300
Quantities for each cable section
4
5
6
9
10
12
Cable Length
2.5 m
1.4 m
TSOL-MS800/MS700/MS600
TSOL-MS400/MS350/MS300

Tsun TSOL-MS800 Specifications

General

Brand	Tsun
Model	TSOL-MS800
Category	Inverter
Language	English