What to do if my TTI FABRICATION Heat Pump is not starting?
If your TTI FABRICATION Heat Pump isn't starting, check if the main power is off. If it is, wait for the power to be reinstated. Also, ensure the switch is on. Replace any burnt-out fuses and switch the circuit breaker back on if it drops out.
Why is the TTI FABRICATION STRATOS 40 blowing air but not heating properly?
If your TTI FABRICATION Heat Pump is blowing air, but the heating isn't good enough, a few things could be happening. First, the air inlet or outlet might be blocked; clean them out. Second, there could be a 3-minute time lag protection activated, so just wait. Finally, the temperature might be set too low; increase it as needed.
Product operating temperature range and parameter variability notes.
Breaker and fuse ratings for different STRATOS models.
Ensuring adequate airflow around the unit for optimal performance.
Advice on placement to avoid environmental factors and ensure stability.
Mandatory connection procedures for inline chemical distributors.
Specific installation requirements for salt chlorinators.
Considerations for pressurized systems and valve selection.
Understanding the information shown on the unit's display.
Steps to set and adjust the desired swimming pool water temperature.
Instructions for setting the internal clock on the heat pump.
Pre-operation checks of connections, wiring, and settings.
Steps for the initial startup and testing of the unit.
General operational advice for optimal performance and safety.
General| Brand | TTI FABRICATION |
|---|---|
| Model | STRATOS 40 |
| Category | Heat Pump |
| Language | English |
To Next Page
