TUBES EVE - Enabling;Disabling Wi-Fi; Connecting to Home Wi-Fi

15
EN
cod. MAN#EVE - Luglio/July 2019
• Wi-Fi on and in access point mode.
The network is called “TUBES EVE
- XXXXXXXXXXXX”, where the Xs corre-
spond to the MAC address of the Wi-Fi
module.
When switched on subsequently, the
device automacally connects to the
Wi-Fi network with the sengs entered
when the app was last used.
How to Enable/Disable the Eve Wi-Fi
network
If you wish to disable the Eve Wi-Fi
network, you must unplug the device
and then plug it back in again. Imme-
diately aer plugging it back in, touch
both touch controls at the same me
for 5 seconds, as soon as the two white
LEDs light up.
Aer 5 seconds, Eve emits a beep, si-
gnalling that the two touch controls can
be released. If the network has been
successfully disabled, 3 beeps will signal
that the Wi-Fi is now switched off.
Use the same procedure if you wish
to switch the Eve Wi-Fi network back
on again. Aer 5 seconds, Eve emits a
beep, and you can release the controls.
If the operaon has been successful, 2
beeps will signal that the Wi-Fi is now
switched on.
TUBES Plug&Play App
Perform the following steps to connect
the Eve network to your home Wi-Fi
network
• Download the TUBES Plug&Play app
from Google Play or the App Store
of your smartphone. In the mean-
me, make sure that your home Wi-Fi
network is switched on.
(The home Wi-Fi connecon to whi-
ch the device is to be connected must
allow TCP connecons towards the
exterior, via the 12345 port. For 99%
of home Wi-Fi connecons, this is the
default seng.)
• Open the app and access your cre-
denals. On your first access, register
by entering a User Name, an e-Mail
address and a Password as requested.
• Exit the app temporarily and access
your phone’s Wi-Fi Sengs. Connect
to the Eve network called “TUBES Eve -
XXXXXXXXXXXX”. The Xs will be replaced
by a series of digits that idenfy the Eve
Wi-Fi network.
NB: it is essenal to access the app
BEFORE connecng to the Eve network:
therefore you must open the app on
your smartphone; only aer doing so
you can search for the Eve network.
Inverng these two steps may cause
problems.
• Once your smartphone is connected
to the Eve network, go back to the app
and click the sengs icon on the top
right of the screen. Click “Congure the
Wi-Fi” to connect Eve to your home
network.
• Select your home network from the
list of available networks, enter the
password for the selected network and
wait for Eve to be correctly configured
for the network.
• Then return to the app’s home page
and click “Add”. Scan the QR code of
your Eve on the label on the device and
rename the device as you wish.
• Eve is now shown in OFFLINE mode.
Connecon of the networks and swi-
tching to ONLINE mode may take a few
seconds. Aer this has been completed
you can begin using Eve from remote
via the TUBES Plug&Play App.
This procedure is required every me
a new Tubes Plug&Play product is
used, or if you change your home Wi-
Fi network, or following a reset of the
product’s sengs. You can use more
than one Tubes Plug&Play device remo-
tely via the app.