Operation Instructions
1. Make sure the bed power cord is plugged into a grounded 110 Volt AC outlet.
• Operating this device with any part of the body in the frame can result in injury. Do not place
arm or head into the frame while operating. Stand clear of device frame before operating.
• Rotating Parts. Keep fingers and arms away when mechanism is moving.
•Pinch Point. Keep fingers and arms away when bed is in movement.
• Electric Powered Mechanism. Electrical hazard may occur if device is plugged into an
inadequate electrical outlet. To avoid electrical shock hazard, make sure the bed is plugged
into a grounded 110 Volt outlet.
2. Before operating, make sure casters are in their proper operating position. Hand Controller
Functions, press button indicated to move bed.
3. To install and raise/lower optional side rails: Slide rails into brackets using pin lock
adjustment.
4. The bed is operated by hand crank and standard 4 function pendant.
A.
* Semi electric bed:
To raise the bed, crank clockwise on point A.
To lower the bed, crank counter clockwise on point A.
* To raise or lower head section:
To raise head section, press head up button.
To lower head section, press head down button.
* To raise or lower foot section:
To raise foot section, press foot up button.
To lower foot section, press foot down button.
-11-
To Next Page
Loading...