41
Paring the Remote Control
You must pair the Bed Frame to a Remote Control before
operation. Ensure the Bed Frame has been unplugged
for at least 10 seconds, then proceed as follows:
1. Plug the Bed Frame into the mains. This will
automatically switch it to Pairing Mode for 30
seconds.
2. In this time, the Bed Frame will search for Remote
Controls to be paired with.
3. During Pairing Mode, press any Button. This will
pair the Remote Control to the Bed Frame.
Unpairing the Remote Control
1. Press and hold the Head and Foot
Platform UP Buttons for at least 15
seconds.
2. Test the Remote Control to check that
it has been safely unpaired.
Moving the Bed Frame Up and Down
You can use the UP and DOWN Buttons to
move the Head and Foot Platforms up and
down:
1. Press and hold the UP or DOWN Button
for the Platform you wish to adjust
2. Wait until the Bed Frame has reached
the desired position
3. Release the UP or DOWN Button
The Bed Frame will move until the Button
is released or the highest / lowest position
is reached.
CAUTION
Risk of minor or moderate injury
Multiple Bed Frames may be in range of your Remote
Control. Operating the wrong Bed Frame may lead to
minor or moderate injury.
• Ensure the Remote Control is paired to the correct
Bed Frame
• Ensure the Remote Control has been safely unpaired
before using it on another Bed Frame
To Next Page
