43
Activating the Child Lock
Always activate the Child Lock when children are near
the Bed Frame. Proceed as follows:
1. Press and hold the Child Lock Button for at least
three seconds
2. Ensure that the LED Array shows “L”. This means
the Child Lock is active
3. To de-activate the Child Lock, press and hold the
Child Lock Button for at least three seconds
Wireless Sync Mode
IMPORTANT:
Wireless Sync Mode allows you to control two Bed
Frames with one Remote Control. If you only have one
Bed Frame, or if your Remote Control does not support
Wireless Sync, continue reading at the next chapter.
Before you activate Wireless Sync Mode,
please ensure:
• Both Bed Frames are standing next to each other
• The Bed Frames will not collide with each other when
moving
• Each Bed Frame can be controlled using its own Remote
Control
To Activate Wireless Sync Mode:
1. Press the Wireless Sync Button on both Remote
Controls (on the left side of the Remote Control)
simultaneously for 3 seconds
2. Ensure that the Wireless Sync Indicator on both
Remote Controls blinks for 5 seconds. When the
blinking stops, the two Bed Frames have been paired
• If the Bed Frames do not move together, repeat the
steps, making sure the Sync Indicator on both Remote
Controls is blinking.
• If only one Remote Control operates both Bed Frames,
deactivate Wireless Sync and repeat steps 1 and 2.
• If both Remote Controls are paired to the same Bed
Frame, unplug the Power Converter of the unpaired
Bed Frame until the LED on the Power Converter
goes out. Then, plug the Power Converterback
in. Press any Button on both Remote Controls to
complete the pairing.
NOTICE
Wireless Sync is designed to work with two Bed Frames.
Connecting more will damage the system.
To Next Page
Loading...
