24 VOLT
POWER INVERTER
IN ORDER TO GET THE MOST OUT OF YOUR INVERTER, THE INSTALLATION PROCEDURE FOUND IN
THE OWNER’S MANUAL MUST BE FOLLOWED CAREFULLY AND THE INVERTER MUST BE USED
PROPERLY. PLEASE READ THOROUGHLY THE OWNER’S MANUAL BEFORE INSTALLING AND USING
YOUR NEW INVERTER.
IMPORTANT
YOUR NEW INVERTER MUST BE POWERED BY A 24 VOLT SOURCE ONLY. SOME
TECHNICAL INFORMATION IN THE OWNER’S MANUAL MAY NOT REFLECT YOUR NEW INVERTER
PERFORMANCES. THE HEREUNDER SPECIFICATIONS APPLIES TO YOUR 24 VOLT INVERTER AND
MUST BE CONSIDERED AS REPLACING THE ONES FOUND IN THE OWNER’S MANUAL.
SPECIFICATIONS
RECOMMENDED MATERIAL HD/HDI-1824 HD-2524 HDI-3024
TUNDRA INSTALLATION KIT CM1200/1500 CM1800/2000 CM2500
WELDING CABLE AWG #2 AWG #1/0 AWG #2/0
DC FUSE (CNL TYPE) 150A 200A 250A
*Refer to the manual for rest of material needed
WARNING! NEVER CONNECT THIS INVERTER TO A 12 VOLT POWER SOURCE, OR ANY OTHER
VOLTAGE THAN 24 VOLT.
WARNING! 24 VOLT CONFIGURATION REPRESENTS A GREATER DANGER THAN 12
VOLT SYSTEMS, PLEASE BE VERY CAUTIOUS WHEN CONNECTING YOUR NEW
INVERTER TO THE BATTERIES
www.tundrainternational.com
To Next Page
Need help?
General
