turbofan E33D5 User Manual

Operation
11
ADDITIONAL ADJUSTMENTS (These can be adjusted whilst Program Mode is Running).
NOTE: Adjustments made during cooking will not be saved to the program.
A. VIEWING STAGE NUMBER AND STAGE TIME REMAINING.
To view the Program and Stage numbers on the Upper Display, e.g. 3.1 = Program 3, Stage 1, and the Total Time Remaining in Stage
remaining on the Lower Display:
- Press ‘P’ key during Program Cooking.
OR
- Turn Timer knob in either direction.
 Upper Display will show Program and Stage, e.g.
 Lower Display will show either,
- Total Time Remaining in Stage.
OR
- Total Elapsed Time of Stage (if Stage is set to ‘InF’).
OR
- Core Probe Set Temp (if Stage is set to ‘CP’).
OR
- Alternate between ‘CP’ and Core Probe Set Temp (if presently in a Core Probe Stage).
Display will revert back to Overall Display after 5 seconds.
B. USING ‘TEMP’ KNOB DURING PROGRAM COOKING.
 VIEWING SET TEMPERATURE
Turn ‘Temp’ knob (in either direction) to display Set Temperature of Current
Stage on Upper Display. Display will revert back to Overall Display after a
5-second delay.
 ADJUSTING SET TEMPERATURE
Hold ‘Temp’ knob in either direction for 3 seconds will enter ‘Temp Edit Mode’
where ‘Temp’ knob can be used to temporarily adjust temperature for the current
stage. Controller will update the Temperature and exit ‘Temp Edit Mode’ after a
5-second delay.
C. USING ‘TIMER’ KNOB DURING PROGRAM COOKING.
 VIEWING STAGE NUMBER AND REMAINING TIME
Turn ‘Timer’ knob (in either direction) to switch the display from Overall
(Program, Total Time remaining) to Current Stage-in-Progress (Stage, Stage
Time Remaining). Display will revert to Overall display after a 5-second delay.
 ADJUSTING REMAINING TIME / ADJUSTING CORE PROBE SET TEMP
Hold the ‘Timer’ knob in either direction for 3 seconds to enter ‘Timer Edit Mode’
where ‘Timer’ knob can be used for temporary adjustment of either:
- Core Probe Set Temperature.
OR
- Stage Time remaining.
The controller will update the value and exit ‘Timer Edit Mode’ after a 5-second delay.
Time remaining can be adjusted between 0-180 minutes, but cannot be set to ‘InF’ or
‘CP’.
Core Probe Set Temp can be set between 50-90°C (122-194°F).
NOTE: Any changes will only apply to the current stage. Any following stages will
revert to the programmed settings.
Here the Oven Set Temperature has been
increased from 150 to 175°C (325 to 350°F).
Here Core Probe Temperature has been
increased from 54 to 75°C (129 - 167°F).

turbofan E33D5 Specifications

General

Brand	turbofan
Model	E33D5
Category	Convection Oven
Language	English