Turbosound NuQ-AN Series - Page 9

16 NuQ-AN Series Quick Start Guide 17
Suspending with Eyebolts
NuQ-AN cabinets can be suspended using optional eyebolts coupled to the internal rigging points provided on the top, bottom and sides.
Remove the appropriate countersunk screws and replace them withshoulder eyebolts, which must have a thread length of at least 18 mm. Use the rear rigging point to
angle the cabinet for optimum room coverage. Cabinets may be hung upside down if required.
IMPORTANT NOTE FOR ALL INSTALLATION METHODS: The mounting of a permanently installed sound system may be dangerous unless undertaken by quali ed
personnel with the required experience and certi cation to perform the necessary tasks. Walls,  oors or ceilings must be capable of safely and securely supporting the
actual load. Themounting accessory used must be safely and securely  xed both to the loudspeaker and to the wall,  oor or ceiling.
When mounting rigging components on walls,  oors or ceilings, ensure that all  xings and fasteners used are of an appropriate size and load rating. Wall and ceiling
claddings, and the construction and composition of walls and ceilings, all need to be taken into account when determining whether a particular  xing arrangement
can be safely employed for a particular load. Cavity plugs or other specialist  xings, if required, must be of an appropriate type, and must be  tted and used in
accordance with the maker’sinstructions.
The operation of your speaker cabinet as part of a  own system, if installed incorrectly and improperly, canpotentially expose persons to serious health risks and
even death. In addition, please ensure that electrical, mechanical and acoustic considerations are discussed with quali ed and certi ed (by local state or national
authorities) personnel prior to any installation or  ying.
Make sure that speaker cabinets are set up and  own by quali ed and certi ed personnel only, usingdedicated equipment and original parts and components
delivered with the unit. If any parts or components are missing please contact your Dealer before attempting to set up the system.
Be sure to observe the local, state and other safety regulations applicable in your country. MUSIC Group, including the MUSIC Group companies listed on the enclosed
“Service Information Sheet”, assumes no liability for any damage or personal injury resulting from improper use, installation or operation of the product. Regular
checks must be conducted by quali ed personnel to ensure that the system remains in a secure and stable condition. Make sure that, where the speaker is  own, the
area underneath the speaker is free of human tra c. Do not  y the speaker in areas that can be entered or used by members of the public.
Speakers create a magnetic  eld, even if not in operation. Therefore, please keep all materials that can be a ected by such  elds (discs, computers, monitors, etc) at a
safe distance. A safe distance is usually between 1 and 2 metres.