support@turbro.com www.turbro.com
02
● During the installation or moving of the appliance, be careful not to pinch, crush, or damage the power
cord. Always unplug the unit from the outlet before cleaning or maintenance operations.
● The batteries in the remote controller must be recycled or disposed of properly. For disposal of scrap
batteries, please discard the batteries as sorted municipal waste at the accessible collection point.
● Do not obstruct the air inlet or outlet of the indoor or outdoor unit. The obstructions cause a reduction
in the operative efficiency of the conditioner with possible consequent failures or damages.
● Do not climb onto or place any objects on the outdoor unit.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
The distance between user and device should be no less than 20cm.
To Next Page
Loading...
