turck BL67 Series - Page 78

78/ 1105 Hans Turck GmbH & Co.KG • Witzlebenstraße 7 • D-45472 Mülheim an der Ruhr • Tel. 0208 4952 0 • Fax 0208 4952 264 • www.turck.com
BL67 Electronic modules
Connection of CANopen nodes
BL67-1CVI
● Independent of the type of fieldbus
and connection technology used
● Degree of protection IP67
● LEDs for display of status and
diagnostics
● Electronics galvanically isolated
from the field level via opto couplers
● Connection of up to 8 CANopen
nodes
● Maximum transmission rate
1 MBit/s
Function principle
BL67 electronic modules are plugged into
the purely passive base modules which are
needed for connection of field devices.
Maintenance is significantly facilitated due
to separation of the connection level from
the module electronics. Flexibility is enhan-
ced because the base modules provide a
choice of various connection technologies.
The electronic modules are completely in-
dependent of the type of higher level field
bus through the use of gateways.
Type BL67-1CVI
Ident-No. 6827223
Number of channels 1
Nominal voltage V
i
24 VDC
Nominal current from supply terminal 100 mA
Nominal current from module bus 30 mA
Power loss, typical 1 W
Inputs / outputs
Type of connection CANopen
Transmission rate 10 kbps up to 1 Mbps
Parameters transmission rate, diagnostics, bus termina-
tion, range of I/O data
bus termination resistor internal
Potential isolation Electronics to field level via opto-couplers
No. of diagnostics bytes 6
No. of parameter bytes 16
Operating temperature 0...+55 °C
Storage temperature -25...+85 °C
Relative humidity 5 to 95 % (indoor), Level RH-2,
without condensation (storage at 45 °C)
Vibration test according to EN 61131
Shock test according to IEC 68-2-27
Topple and fall according to IEC 68-2-31
and free fall according to IEC 68-2-32
Electromagnetic compatibility according to EN 61131-2
Degree of protection IP67
General technical data see page 21
LED
91
32
77,5
195
13
145