Need help?Do you have a question about the turck BL20-PG-EN-V3 and is the answer not in the manual?
General| Product Type | Gateway |
|---|---|
| Model | BL20-PG-EN-V3 |
| Power Supply | 24 V DC |
| Dimensions | 101 x 45 x 114.5 mm |
| Operating Temperature | -25 °C to +55 °C |
| Type | Gateway |
| Protection degree | IP20 |
| Interface | Ethernet |
| Operating Voltage | 24 V DC |
| Communication Protocol | EtherNet/IP |
| Protocol | EtherNet/IP |
Manual describes hardware and functions of CODESYS V3-programmable gateways.
Explains graphical symbols and signal words for warnings, notes, and actions.
Provides important general information and safety aspects for operating electrical equipment.
Explains how programmable gateways function as autonomous or decentral PLCs.
Illustrates the physical layout and components of BL20 and BL67 gateways.
Provides physical dimensions for BL20 and BL67 gateways in diagrams.
Shows internal block diagrams illustrating the architecture of BL20 and BL67 gateways.
Lists detailed technical specifications for the devices.
Technical specifications specific to the BL20-PG-EN-V3 model.
Technical specifications specific to the BL67-PG-EN-V3 model.
Explains how fieldbus connections are implemented for BL20 and BL67.
Describes the power supply connections for the devices.
Details the function and connection of the USB Device port.
Details the function and connection of the USB Host port.
Describes how to reset the device's IP address to default settings.
Explains setting the IP address using rotary switches.
Details how to configure the IP address using DHCP.
Outlines the process for resetting the device to factory default settings.
Explains IP address configuration using the Turck IP Address Tool.
Details methods for resetting the device to factory default settings.
Describes resetting to factory settings using the IP Address Tool.
Explains resetting to factory settings via the web server interface.
Details the LED indicators for the BL20 model.
Details the LED indicators for the BL67 model.
Explains how to access the device using SFTP protocol.
Details methods for updating the device firmware.
Describes firmware update using a USB storage device.
Describes firmware update using a DTM.
Lists configurable parameters for the BLxx-PG-EN-V3 device.
Explains how to access and interpret system diagnostic information.
Describes how to access and interpret I/O module diagnostics.
Lists the CODESYS libraries supported by the gateways.
Guides on initial setup and installation for CODESYS.
Details how to configure the gateway as a Modbus TCP Master.
Details how to configure the gateway as a Modbus TCP Slave Device.
Details how to configure the gateway as a PROFINET Device.
Details how to configure the gateway as an EtherNet/IP Slave.
Lists requirements and recommendations for compatible USB storage devices.
Details the various read and write functions of the USB Host port.
Step-by-step instructions for executing USB Host port functions.
Explains how to access and configure the device via the web server.
Details the default IP address and how to access the web server.
Covers changing network parameters like IP address via the web server.
Explains how to configure fieldbus interfaces, reboot, and reset.
Covers parameterization of module I/O channels via the web server.
To Next Page
