CODESYS-functions
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
58
5.6.2 Configuring the EtherNet/IP™-slave in EtherNet/IP™ PLC
The following example describes the configuration of the EtherNet/IP™-slave in "RSLogix5000"
V20.1. from Rockwell Automation.
The EtherNet/IP™-slave is configured as standard EtherNet/IP™-slave (Communications Adapter)
in RSLogix.
Hardware in the example:
Controller. Logix 5572™ (Allen Bradley)
EtherNet/IP™-Bridge 1756EN2TR (Allen Bradley)
BL20-PG-EN-V3, FW 1.0.5.0
Installing the EDS-file
Install the device's EDS-file (Turck CDS3.eds) in the configuration software. It can be downloaded
from www.turck.com
The device is added to the device catalog in RSLogix as „CDS 3 Ethernet/IP Slave“.
Fig. 41: "CDS 3 Ethernet/IP Slave" in the device catalog in RSLogix5000
To Next Page
Loading...
