turck BL20-PG-EN-V3 - Restore IP Address; Address Setting via Rotary Coding Switches

19
V01.0| 2016/04
Programmable Gateways BLxx-PG-EN-V3
3.5.4 USB Host port
The USB Host port is designed as USB2.0-A-socket and serves for connecting USB memory sticks for
the restore and backup of CODESYS programs and for the actualization of the device firmware (see
Functions of the USB Host port (page 61)).
3.6 Device addressing and operation mode setting
The device address and the operation mode are set using a combination of the 2 rotary coding
switches and the DIP switches at the device.
A „-“: Switch position is irrelevant
Fig. 7: Rotary coding and DIP switches at 
BL20-PG-EN-V3
Fig. 8: Rotary coding and DIP switches at 
BL67-PG-EN-V3
Rotary cod-
ing switches
DIP switches A Mode Description
5 (MODE)4321
00 1 0 0 - - Restore IP Reset the device to d
efault settings 
(see page 20):
IP address 192.168.1.254
Subnet mask 255.255.255.0
gateway 192.168.1.1
Auto-negotiation/
AutoMDIX
active
QuickConnect/FSU inactive
40 1 ----DHCP Addressing via DHCP (see page 21)
50 1 - - - - PGM Addressing via PGM (see page 21)
60 1 - - - - PGM-DHCP Addressing via PGM-DHCP (see page 22)
State of delivery
90 1 - - - - F_Reset Reset to factory settings (see page 23)
1-99 0 - - - - Static
rotary
Sets the last byte of the IP address (see page 20).
The other 3 byte are taken from the IP address, which was
stored in the device before.
00 0 0 0 - - Address Sets the last byte of the IP address to 100.
The other 3 byte are taken from the IP address, which was
stored in the device before.
1 = 5 VDC
2 = D –
3 = D +
4 = GND
1234
v
0
1
2
3
4
5
6
7
8
9
0
1
2
3
4
5
6
7
8
9
x10
x1
0
9
8
7
6
5
4
3
2
1
0
9
8
7
6
5
4
3
2
1