turck BL20-PG-EN-V3 - PROFINET-Device; Configuring the PROFINET-Device in CODESYS

51
V01.0| 2016/04
Programmable Gateways BLxx-PG-EN-V3
5.5 PROFINET-Device
5.5.1 Configuring the PROFINET-device in CODESYS
 Add the PROFINET_Device to the Ethernet interface using the "Add Device"-function and config-
ure the length ofthe in- and output data, which have to be exchanged with the higher-level PROF-
INET-master.
Properties
max. number of I/O data 1024 byte in total
(512 IN + 512 OUT)
NOTE
It can be necessary to increase the PROFINET cycle time for larger BLxx-stations.
Fig. 34: Configuring the PROFINET-device in CODESYS
NOTE
When configuring the I/O-data the following has to be observed: The input data in CODE-
SYS have to be configured as output data in the PROFINET-master configuration and the
output data in CODESYS as input data.
The data thus have to be configured in reverse order in the PROFINET-master configura-
tion ( see also Configuring the in- and output data (page 55)).