73
V01.0| 2016/04
Programmable Gateways BLxx-PG-EN-V3
7.10 Network Configuration
On the "Network Configuration"-page, network-relevant settings can be changed.
7.10.1 Change network parameters (port settings, IP address, etc.)
The device's network settings can be changed under "Network Configuration" only by users having
administrator rights.
Change network parameters
Change the network parameters in the web server.
Write the changes into the device via "Submit".
The device has accepted the new settings, the settings have become active.
NOTE
The access of the web server to the station is only possible, if the station already has an IP
address, Device addressing and operation mode setting (page 19).
After a reset to factory settings, the device can be accessed using the IP address
192.168.1.254. This IP address is not stored permanently in the device.
If the device is set to "ROTARY" mode (Address setting via rotary coding switches
(Static rotary) (page 20)), than the last byte of the IP address can not be changed via the
web server.
Fig. 50: Web server with Network Configuration
NOTE
"Reset" only resets the changes done in the web server mask back to the original values.
The function does not influence the device itself.
To Next Page
Loading...
