www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441 9
-> Let the program run
IMPORTANT NOTES:
1. When the programming has nished, remember to solder pin 1 back down. (BL20 users)
2. Every time you ash and new a new card you must hit the reset on the Universal Programming Dongle.
TROUBLE SHOOTING SOLUTIONS
-> If you get an error message in Memtool 3, here are some possible faults.
1. You forgot to hit the reset button on the Universal Programming Dongle. Hit the reset.
2. The Card Connecter is touching the even connections on the card. Readjust it.
3. You did a poor job unsoldering pin 1. Check your work and try it again.
4. You allowed the soldering iron to touch the microchip, which in turned burned up the card’s circuitry. Throw it away.
5. You didn’t set up the Universal Programming Dongle correctly. Recheck it.
6. You ran more than 5V through the dongle and the dongle burned up. Try a dierent one.
7. Maybe the card is bad to start. Check it in PACTware of Xion Tool.
8. If one card just won’t connect, try a dierent card.
IMPORTANT NOTE:
EVERY TIME YOU DO A TROUBLE SHOOTING SOLUTION YOU MUST COMPLETELY CLOSE OUT AND
RESTART MEMTOOL.
To Previous Page
Loading...
