TURFCO 85877 - Safe Operation on Slopes and Inclines; Slope Operation Guidelines; Slope Operation Warnings

13
85876 & 85877 RevA
TURFCO T3100 APPLICATOR
Operation on Slopes, Inclines or Hills
(See Figure 7)
Forsafetyreasons,thebestwaytodriveupordownaslopeisata45ºdegreeangletotheslope.Thiswill
keep you from being directly above or under the mass of the machine. This machine is only rated to go on
slopesof15ºdegreesorless.Slopesofmorethan15ºdegreescouldcauseinjurytotheoperatorordamage
to the machine. Roll overs can occur,usingthemachinetotraversealongaslopeofmorethan15ºdegrees
isnotrecommended.Youshouldalwaysusewalkingapplicatorsonslopesmorethan15ºdegrees.
●Donotturnthemachinewhileonaslopeorincline.
●Ifonemustoperateacrossaslope,anglethemachine45ºdegreestothedirectionoftheinclineno
matter if you are going up or down the slope.
●Donotoperatethemachineacrossthefaceofaslopeorat90ºdegreeanglestotheslope.
The Turfco T3100 Applicator is not designed to be operated
on any incline or slope exceeding 15º Degrees.
Operation on inclines of more than 15º degrees can result in
injury and/or damage to the machine.
Operation on inclines exceeding the 15º degree limit can cause spillage of materials
WARNING
OPERATION
15° MAXIMUM
15° MAXIMUM
OP85876-05RevA
FIGURE 7
15° MAXIMUM
15° MAXIMUM