34
85876 & 85877 RevA
TURFCO T3100 APPLICATOR
SERVICE AND MAINTENANCE
Operator Daily Inspection
INSPECTION - A general inspection is a good idea
before the machine is ready to used or put away.
Beforeandaftereachuse,checkthefollowingitems:
● Inspectfordamagedormissingguardsorcovers.
Do not operate any machine with missing or
damaged guards.
● InspectentireT3100fordamagedor inoperable
components. Do not operate any machine with
damaged or inoperable components.
WARNING
SERVICE AND MAINTENANCE
TO AVOID SERIOUS INJURY,
Do Not Service, Inspect, Lubricate Or
Adjust The T3100 With Any Part of the
Sprayer or Spinner Assembly Operating
or With the Engine Running.
All Of The Service And Adjustment Procedures
Involve Or Are Near Rotating And Moving Parts.
Work Safely, Follow All Hazard Warnings, Decals,
Safety Precautions And Wear The Appropriate
Safety Gear.
● Inspect the entire machine for loose fasteners.
Retighten as required.
● Inspect all the operator controls for proper
operation.
● Checkthetiresforproperination.
● Inspect the spinner assembly spinner wheels.
Check for proper alignment, damage, wear, and
missing hardware.
● Checkforabuildupoffertilizeronspinnerassembly
components and the hopper gate. Check for a
buildup on and under the spinner wheels. Check
for debris caught in spinner wheel.
● Check for a buildup of fertilizer on components
under the hopper.
● Periodically inspect the steering cables for wear
or damage.
● Protect from rust and moisture with a very light
coating of machine oil.
INSPECTION OF THE V-BELTS - The lower front
cover needs to be removed so you can clean or inspect
the belts. To remove the cover, twist out the two thumb
screws and slide the cover forward. You may now
inspect and clean the belts or grease the belt idler.
OP85876-12RevA
SPREADER GATE LEVER
SPREADER HOPPER
SPINNER WHEEL
SPRAY NOZZLES
FRONT COVER
SPINNER WHEEL
UPPER PULL PIN
SPINNER WHEEL
LOWER PULL PIN
TANK DRAIN PLUG
(ONE PER SIDE)
To Next Page
Loading...
