21
Place the included Mounting Template
on the toilet, aligning its front edge with
the front edge of the toilet rim. Remove
the Base Plate from the bottom
of the TUSHY by pressing the quick
release button and sliding it out. Align
the Base Plate in the Mounting Template
over the toilet bolt holes, ensuring
it is centered and straight, with
the rubber non-slip pads facing down.
Tape the Mounting Template in place
for ease throughout this process.
Insert the included Top-Mounting Rubber Inserts
and Mounting Bolts into the toilet bolt holes until they are
nearly flush with the surface. Keeping the Mounting Bolts
inside the Rubber Inserts will provide a firm guide to push
the rubber down into the holes. Once the Rubber Inserts
are in place, unscrew the Mounting Bolts and set them aside
until the end of Step 5.
Attach your TUSHY Wave Base Plate
to the bowl
STEP 5
TUSHY TIP
If you’re having trouble getting the Rubber Inserts into
the toilet bolt holes, use some soapy water to help them
slide in easier!
To Next Page
Loading...